- Advice
- 0 likes
- 3530 views
- 0 comments
If your Dolphin robot's cable ends up in tight coils after a few cleaning cycles, you're not alone. A twisted cable is one of the most common problems with pool robots. It shortens the robot's reach, can stop it climbing walls properly, and over time it damages the cable itself. Here's why it happens, what a swivel does, and how to choose the right replacement.
Why your robot's cable twists
A pool robot doesn't just go back and forth: it turns at every wall and changes direction many times per cycle. Each turn adds a little twist to the cable. After a few hours, those small twists add up into coils and knots. Leaving the cable coiled tightly between uses, or in the sun, makes it worse, because the cable keeps the shape it was stored in.
Quick fix: unplug the robot, lay the cable out straight in the sun for an hour or two and let it relax. This helps, but if the cable twists again every week, a swivel cable is the lasting solution.
Swivel or fixed cable: what's the difference?
A swivel is a rotating joint on the cable. As the robot turns, the swivel turns with it, so the twist is released instead of building up along the cable. Many Dolphin robots are offered with a swivel cable, and for many models a swivel replacement is available, such as the 18 m swivel cable for the E40i and other models (99958906-DIY).
| Fixed cable | Swivel cable | |
|---|---|---|
| Twisting | Builds up over time | Released by the rotating joint |
| Maintenance | Needs regular untangling | Much less handling |
| Best for | Small, simple pools | Most pools, especially with steps or curves |
Matching the cable to your model
Dolphin cables are not universal. The plug at the robot end, the number of wires and the connection to the power supply differ between series, so the cable must match your robot. Two rules make it simple:
- Check your model: the label on the robot or the power supply tells you which robot you have. Our choose your robot page lists parts by model.
- Use the part number: Maytronics cables have a reference such as 99958906 or 99958903. If your old cable or manual shows one, order the same reference. "DIY" versions are designed to be fitted at home.
For example, the E30 and S200 take the 18 m floating cable 99958903-DIY.
Choosing the length
The cable must reach the far corner of the pool and still let the robot climb the walls. A simple rule: add the pool's length, its depth at the deepest point, and a margin of a couple of metres to reach the power supply. Too short and the robot can't reach everything; much too long and the extra cable floats around and tangles more easily. If in doubt, pick the length your robot came with.
Fitting the new cable at home
Most DIY cables connect to the robot's motor unit and to the power supply without special tools. Always unplug the power supply first, and follow the instructions for your model carefully, especially the seals where the cable enters the robot: they keep water away from the motor. If the power lead to the mains is damaged too, a power cable for the Dolphin transformer (5898411LF) is available separately.
Then look after it: uncoil the cable after each use, store it loosely in the shade, and never pull the robot out of the water by its cable. Browse all our Dolphin robot cables, or contact us with your model and we'll find the right one.
Products on poolfiltersplus.com are compatible with Dolphin (Maytronics) robots; we are not affiliated with Maytronics.
Comments (0)